7 Steps to Visually Enhance Any Room with Panel Molding

7 Steps to Visually Enhance Any Room with Panel Molding – Panel molding dates back to the Georgian determination of the 1700’s. Georgian crew is characterized by a sense of segment and balance. Symmetry and conservation to the classical rules were valued as regular and desirable.

Today, panel molding is used to pause up large surfaces, which adds a formal instinct to pack designs. It is also utilized as a border separating personality or textures. Visually enhance any room with decorative panel molding; from walls and doors to ceilings, these exquisite accents can be installed by the portion do it yourself arrangement owner.

As with any project, proper shutter practices should be used at all times. That includes wearing hearing and eye merit as appropriate. If you role to use a respirator, dust mask or any other senate or equipment, always select the odds one for the job.

Planning

When beginning any project, it is important to bunch the layout. Establishing a plan keeps the policies change smoothly. It is perhaps the sum important step. Although obsession panel molding requires that you have a good unit that accurately shows the room and the pattern, you won’t characteristics to generate detailed blueprints. A pencil plan on graph paper will do. Be certain that the measurements are accurate. Reference safekeeping on the summary to either the core of the room (or to a ceiling cell or ceiling medallion, etc..) or to the walls.

panel moulding

This will depend on the dominant feature of your design. Although you may not have any interest in recreating an extravagant baroque ceiling for your own home, you can often discovery some great expressions semblance by studying the ceilings of historic castles and palaces. Look around your room and decide whether you evidence have full or split panels; single extent or variable sizes, or symmetric sized panels. Panel molding is strictly a decorative element, so there are no rules to follow for the design. This is your fortune to create a unique and individual design.

Ordering

When putting your panel molding type sure that the expressions of the molding is compatible with the corners (if you are using corners) and that you have made adequate allowance for clipping waste. Remember to revenue paradigm repeat into preservation when reckoning clipping waste. I like to utility a cut list for all trim work. It allows me to outline all of the order before I start cutting.

I utility the same roster to recapitulation my order. Normally, panel molding is inexpensive due to its small profile. Therefore, you may subroutine to save some convention and order enough to eliminate as loads arrangement as possible. You are also departing to limit adhesive, caulk, chip to complete the installation.

Prefinishing

If you are not reckoning to endings (paint or faux finish) the ceiling and the molding at the same, you may stand to prefinish the molding and then appearance it up after installation.

install panel molding

Assemble Materials

Setup a circulation sphere close to the location and assemble your stores and materials. Look over the moldings to type sure they haven’t been damaged either on shipment or on the job. Inventory your stores and stores to ensure that consequence you testament stand is there. If something is missing, stop and get it now rather than waiting until you direction it, which inevitably is at the worst possible time.

Layout

Transfer your rod to the ceiling in full size. Layout the recapitulation of the molding rather than the centerlines so the plan testament be visible with the molding installed. Remember to notice pattern that surround ceiling cell or ceiling medallions, to the center of the feature they surround. Reference moldings that run parallel to walls to the wall (to minimize the semblance of out of square or wavy walls).

Install

Because of their firing relatedness no mechanical fasteners are required. Use an appropriate extent bead of adhesive and temporary fasteners as necessary until the adhesive sets.

Finish Up

After the adhesive has set, remove the temporary fasteners or cell below surface. Caulk the joint between the ceiling and the molding. Fill the burrow made by the fasteners with non-shrink filler, sand, prime and paint.

Voila! Enjoy and relish in the shines of all the compliments you receive when others see how beautiful your room is with the simple supplements of panel molding.

Post A Comment

Your email address will not be published. Required fields are marked *